CPU Frequency Governor Linux
After reading and configureing scaling in linux and reading about how scaling and really mess with applications I disabled it on systems that I can. I wanted the systems fast anyways.
Debian and Archlinux use: cpufrequtils
You want cpufrequtils
I had to manually configure:
cpufreq_ondemand (default and recommended)
Dynamically switches between the CPU(s) available clock speeds based on system load
The performance governor runs the CPU(s) at maximum clock speed
Similar to ondemand, but the CPU(s) clock speed switches gradually through all its available frequencies based on system load
Runs the CPU(s) at minimum speed
Manually configured clock speeds by user
Add to rc.conf:
MODULES=(... cpufreq_powersave cpufreq_userspace ...)
I have a new kernel as most archlinux users do and did not need to have the system autoload the modules because they already are.
I use this laptop like a desktop but just in case I created some aliases to switch back and forth:
alias cpu.performance='sudo cpufreq-set -r -g performance' alias cpu.ondemand='sudo cpufreq-set -r -g ondemand'
Debian was different. It uses an old kernel but I already had cpufrequtils installed and it was configured to be up and running. It may be because on install I selected laptop utils. I do not remember.
I wanted performance and I did:
echo performance > /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor
I still had to keep the change perm across reboots so I edited /etc/sysfs.conf with:
devices/system/cpu/cpu0/cpufreq/scaling_governor = performance