Difference between revisions of "Matrox DualHead2Go (and possibly TripleHead2Go) on Linux"
From Hack Sphere Labs Wiki
| Line 12: | Line 12: | ||
=Notes= | =Notes= | ||
| + | * I really do not think that OS matters for anything but configuration. | ||
* Triplehead2Go Mode expander: http://www.matrox.com/graphics/en/support/drivers/download/th2go/tmet/ | * Triplehead2Go Mode expander: http://www.matrox.com/graphics/en/support/drivers/download/th2go/tmet/ | ||
* (2048x768@60Hz?) or higher? | * (2048x768@60Hz?) or higher? | ||
Revision as of 08:49, 4 July 2012
Basics:
- Install drivers on Windows box and then plug device in
- Update firmware and reboot
- Decide on what resolution that your Linux box is going to use after looking at the display modes in the Matrox software
- Set the Matrox box to that mode by using the Matrox software
- Note the overall output resolution and refresh rate
- Move device over to your Linux box and set the Linux box at the same resolution AND refresh rate
Notes
- I really do not think that OS matters for anything but configuration.
- Triplehead2Go Mode expander: http://www.matrox.com/graphics/en/support/drivers/download/th2go/tmet/
- (2048x768@60Hz?) or higher?
