View source for Matrox DualHead2Go (and possibly TripleHead2Go) on Linux

* From: http://ubuntuforums.org/showthread.php?p=12075231#post12075231

Basics:
# Install drivers on Windows box and then plug device in
# Update firmware and reboot
# Decide on what resolution that your Linux box is going to use after looking at the display modes in the Matrox software
# Set the Matrox box to that mode by using the Matrox software
# Note the overall output resolution and refresh rate
# Move device over to your Linux box and set the Linux box at the same '''resolution''' AND '''refresh rate'''



=Notes=
* I really do not think that OS matters for anything but configuration.
* Triplehead2Go Mode expander:  http://www.matrox.com/graphics/en/support/drivers/download/th2go/tmet/
*  (2048x768@60Hz?) or higher?
* Ended up using 2048*768 @ 60Hz